Memory

1GB DDR3，800MHz

eMMC

8GB eMMC

PMIC

AXP228，support dynamic FM, Coulomb and so on

4G Module

QUECTEL EC20，PCIE interface

WiFi / BT

Realtek8723 WiFi / BT integrated module, support 802.11b / g / n, Bluetooth 4.0, USB interface

GPS

High sensitivity, tracking sensitivity of -165dBm, capture -148dBm

Camera

Standard 24Pin Camera Interface，support OV3640，3 million pixel camera

Ethernet

RTL8211E Gigabit Ethernet PHY

LCD

Configuration of 10.1 inch LVDS capacitive touch LCD, resolution: 1280 * 800

Audio

IIS interface，support recording, playback, and with external power amplifier

HDMI

1*HDMI 1.4 interface（1080P/60Hz）

UART Serial

2 ports for serial communication and debug output

SD/HSMMC

2*SD 2.0, the board leads an SD / MMC card slot

USB 2.0 HOST

Through 1* USB HUB extend to 2 *USB 2.0 HOST interface

OTG

1*OTG Interface

Function Button

Power button, reset button, interrupt button and so on

LED Indicator

3*LED Indicator

Buzzer

1*MMBT3904/SOT buzzer

Battery

For RTC use，round lithium   battery

Power Supply

AC220 DC12V/5A power adapter with power switch and indicator light

Size

52*38*16CM

1

Human Body infrared Sensor

●  Operating voltage：DC3.3V

●  Quiescent current：<50uA  

●  Level output：high 3.3 V /low 0V

●  Trigger mode：L non-repeatable trigger/H repeat trigger (default repeat trigger)

●  Delay time：0.5-200S (adjustable) can be made range of zero seconds - tens of minutes

●  Block time：2.5S(default) can be made range of zero seconds - tens of seconds

●  Sensing angle：<100 degrees taper angle

●  Operating temperature：-15～70℃

●  Induction lens size：Diameter: 23.2mm Fresnel lens

●  Size：29.2mm x 40mm

2

Vibration Detection Sensor

●  High sensitivity vibration sensor, all-round induction vibration

●  Comparator output, clean signal, good waveform, strong drive ability, extends 15mA

●  Operating voltage：3.3V-5V

●  Output type: digital switch output (0 and 1)

●  Can detect the vibration of the surrounding environment, the sensitivity is adjustable

●  For a variety of vibration trigger, report alarm, intelligent car, earthquake alarm, motorcycle alarm etc.

●  Compare with the normally open vibration sensor module, this one has longer vibration, can drive the relay module

3

Magnetic Sensor

●  12-bit ADC and low-interference AMR sensor, can achieve 5 mm Gaussian resolution in ± 8 Gaussian magnetic field

●  Built-in self-test function

●  Low voltage operation (2.16-3.6V) and ultralow power consumption (100uA)

●  Built-in drive circuit

●  I2C digital interface

●  Leadless package construction

●  Wide magnetic range (+/- 8Oe)

●  With the related software and algorithm supportŸ Maximum output frequency up to 160Hz

4

Pressure   Measurement Sensor

●  Pressure range：300 ~ 1100hPa (elevation 9000m ~ -500 m)

●  Voltage：1.8V~3.6V（VDDA），1.62V~3.6V（VDDD）

●  LCC8 package：lead-free ceramic carrier package (LCC)

●  Size：3.6mm x 3.8 x 0.93mm

●  Low power consumption：5μA in standard mode

●  High precision：in low power consumption mode, the resolution is 0.06hPa (0.5 m)

●  In high linearity mode, the resolution is 0.03hPa (0.25 m)

●  Temperature output

Ÿ●  I2C interface

●  Temperature compensation

●  Lead-free, in compliantwith RoHS

Ÿ●  MSL 1 reaction time: 7.5ms

●  Standby current: 0.1μA

●  No external clock circuit required

5

Light / Light   Intensity Sensor

●  This module uses ROHM original BH1750FVI chip

●  Power supply: 3.3V

●  Illumination range: 0-65535 lx

●  Sensor built-in 16bitAD converter

●  Direct digital output, omitting complex calculations, omitting calibration

●  No distinguish between ambient light sources

●  Spectral characteristic is close to visual sensitivity

●  High accuracy of 1 lux for a wide range of brightness

●  Standard NXP IIC communication protocol

6

Smoke   Sensor

●  Loop voltage: ≤15V (AC or DC)

●  Heating voltage: 5 ± 0.2V (AC or DC)

●  Load resistance: adjustable

●  Heating resistance: 31Ω ± 3Ω

●  Heating power consumption: ≤900mW

●  Detection concentration range: 100ppm-20000ppm (different gas concentration range is different)

●  Operating temperature: -10 ~ 50 ℃ (nominal temperature 20 ℃)

●  Storage temperature: -20 ~ 70 ℃ (nominal temperature 20 ℃)

●  Relative humidity: less than 95% RH (nominal humidity 65% RH)

●  Oxygen concentration: 21% (standard condition) (oxygen concentration will affect the sensitivity characteristics), the minimum value is greater than 2%

●  Clean air voltage: ≤1.5V

●  Sensitivity: ≥3%

●  Response time: ≤ 1S (preheat 3-5 minutes)

●  Reply time: ≤ 30S

●  With signal output indicator

●  Dual signal output (analog output and TTL level output)

●  The low valid TTL output, can be directly connected to the microcontroller IO port

●  Analog output 0 ~ 2.5V voltage, the higher the concentration, the higher the voltage

●  Have good sensitivity to liquefied gas, butane, methane, smoke and so on

7

Infrared Radiation   Sensor

●  High reliability and fast response

●  Slot width 5mm

●  With the output status indicator, when lights off, the output high level, otherwise, output low level

●  Has block, high level output, otherwise, low level output

●  Comparator output, clean signal, good waveform, strong drive ability, exceeds 15mA

●  Operating voltage 3.3V-5V

Ÿ●  Output type: digital switch output (0 and 1)

●  Use a wide voltage LM393 comparator

8

Temperature and   Humidity Sensor

●  full scale calibration, two-wire digital output humidity measurement range: 0~100% RH

●  Temperature measurement range: -40 ~ +123.8 ℃

Ÿ●  Humidity measurement accuracy: ± 3% RH

Ÿ●  Temperature measurement accuracy: ± 0.4 ℃

●  Response time: 8s (tau63%) Low power consumption 80μW (12-bit measurement, 1 time / s)

9

Relay Control   Module

●  The module complies with international safety standards and there is separation slot between the control area and load area

●  The module has optocoupler isolation, touch is more reliable and stable

●  Double-sided FR-4 circuit board design, high-end chip production process

●  With Song Le genuine relay Control

●  With power and relay action instructions, pull bright, open does not shine

●  When the signal input has a low level signal, the common terminal and the normally open terminal are turned on

●  The relay can directly control various devices and loads

●  There is one normally open and one normally closed contact

●  Blue KF301 terminal access control line is more convenient

●  low level Input is active